2013 Azimut Grande 116

• Make: Azimut

• Model: Grande 116

• Condition: Used

• Category: Power

• Construction: Fiberglass

• Has Hull ID: No

• Length: 35.36 m / 116 ft

• Length Overall: 35.36 m / 116.25 ft

• Beam: 25.08 ft ft

• Make: MTU

• Model: 16V 2000 M93

• Drive Type: V

• Fuel: diesel

• Engine Power: 2400|horsepower

• Type: Inboard

• Engine Hours: 295

• Engine Location: Port

• Model: 16V 2000 M93

• Drive Type: V

• Fuel: diesel

• Engine Power: 2400|horsepower

• Type: Inboard

• Engine Hours: 295

• Engine Location: Starboard

• Total Engine Power: 4800|horsepower

Specifications

SIZE AND MAIN CHARACTERISTICS:

Length overall (Loa) 35.46 [m]
Waterline length (Lwl) 28.58 [m]
Beam at main section (B) 7.4 [m]
Beam overall (Bmax) 7.65 [m]
Gross tonnage 250 [GT]
Draft to keel at full load (Tfl) 1.41 [m]
Draft to keel at half load (T1/2) 1.36 [m]
Draft to keel at 1/3 load (T1/3) 1.34 [m]
Hull height 3.68 [m]
Height above waterline 9.5 [m]
(half load displacement – no antennas)
Full load displacement (1) 148 [t]
Half load displacement (2) 139 [t]
1/3 load displacement (sea trial)(3) 136 [t]
Fuel capacity 18000 [l]
(daily tanks + structural tank)
Fresh water capacity 2800 [l]
Black water capacity 1400 [l]
Gray water capacity 1400 [l]
Speed @ fuel stop power=70%
(4) ~ 21 [kns]
Maximum speed (4) ~ 26.5 [kns]
(fuel stop power= 100% MCR)
Range at fuel stop power=70%
(5) ~ 485 [nm]
Aft deadrise angle 9.4 [°]
Maximum passengers number 18
Owner and guest accomodations 8 persons in 4 cabins
Crew accomodations 5 persons in 2 cabins

 

PROPULSION AND STEERING:

MAIN ENGINES 2 MTU 16V 2000M93. Diesel engines,
16v cylinders , with this
characteristics:
· MCR: 1790 kW @ 2450 RPM
· Single piston displacement : lt. 2,23
· Stroke: 156 mm
· Bore: 135 mm
· Spec. consumption @ M.C.R.: 207
g/kWh
(tollerance + 5%, ISO 3046
conditions ; L.H.V. Fuel = 42800
kJ/kg)
· Displays
· Smart Line electronics.
GEARBOXES 2 ZF 3060 V, reduction rate 3:1,
installed on resilient mountings.
TRANSMISSION V-Drive with universal joint.
SHAFTS MODEL : BCS
Marinox 17, Æ 110 mm, supported by
brass stands and tubes.
Tides shaft seals.
PROPELLERS · Number of blades: 5,
· Diameter: 1180 mm,
· Material: NiBrAl.
RUDDERS MODEL : BCS MT-620
Rudderholes and pole of the rudders
in Marinox 17.
Bar and yoke in carbon steel.
INTRUDER AISI 316 steel, fixed. Total width: 4620
mm .

FLAPS MODEL : BCS MY4000

AISI 316L steel . Width (each): 550
mm .
BOW THRUSTER · MODEL : TRAC 50 Hp
· System : electric
· Power : 35.8 kW (50 Hp).
· Thrust: 6130 N (625 Kgf).
· Protection grid on tunnel.